Vicks V3100 Operations Instructions download pdf (Page 3)

4 5

Using Your Vicks Filtered Cool

Moisture Humidifier

First Time Use

Read all instructions before using this appliance. With proper care and maintenance,

the humidifier should be able to provide at least 18 hours operation per filling.

Unpack and remove all packing material from the Water Tank and Base. Completely unravel

power cord and place unit on a flat, stable surface at least 5 inches away from walls and heat

sources. Do not use product if cord has been damaged. Place cord out of the way where it

cannot be pulled or stepped on. Follow the directions below to fill and operate the Humidifier.

Filling the Water Tank

Always UNPLUG the humidifier before filling.

1. Remove the Water Tank from the Base and turn it upside down. Turn the Tank Cap

counterclockwise to open.

2. Fill the Water Tank with clean, cool, tap water and replace the Tank Cap by firmly turning

clockwise. Turn the tank upright and check Tank Cap for leaks. If any water drips from

Tank Cap, remove it and re-tighten. Make sure the circular rub cap Gasket (o-Ring) is in

place when replacing Tank Cap — this prevents water leakage.

3. Carry Water Tank using one hand on the handle and one on the bottom of the Tank.

4. Be sure the Water Tray and Wicking Filter are in place.

5. Replace the Water Tank on the Base by aligning the Tank Cap into the Water Tray.

Caution:

Do not use hot water, which may damage the wick.

Do not add any medication or other additives to the water.

Do not pour any water into the outlet.

Operating Instructions

1. Do not operate the humidifier without water in the Water Tank or without a Wicking Filter

installed.

2. After filling the humidifier, be sure the Power Switch is in the OFF position, then plug the

power cord into a 120 volt AC wall outlet. CAUTION: DO NOT PLUG IN THE CORD

WITH WET HANDS; ELECTRIC SHOCK COULD RESULT.

3. For optimal performance, soak wicking filter in water before use.

4. Turn the Switch to either the Hi or Low position. The Power Indicator will illuminate and

the fan will start turning.

5. Direct Outlet away from walls and furniture. If condensation forms on walls or windows,

or if indoor relative humidity exceeds 50%, turn the Power Switch to the low setting, open

door to room where humidifier is operating, or turn unit off.

6. Turn the humidifier off and unplug the humidifier before removing and refilling the Water

Tank.

1 2 3 4 5 6 7 8 9 10 11

No comments

Vicks V3100 Operations Instructions Page 3